Upínací sady TMK verze B, ocel zink./nikl. potažené, otvor Ø 20 mm

Material: Steel, with corrosion protection (inner bush and nut nickel-plated, outer bush zinc-plated).

  • For fixing a hub (e.g. drive wheel, rotor or similar) on a shaft.
  • For medium torques.
  • Self-centering.
  • With a second hexagon to hold against while tightening the nut.
  • Axial offset during mounting (can be compensated by correct positioning).

Mounting
It is essential to degrease the shaft and hub. There must be little oil only between the two hexagons. The locking assembly must not get in contact with any fixed components. Hold the back hexagon with a slim open-end wrench and tighten the front hexagon with a torque wrench clockwise to the torque TA as per the table.

Demounting
Hold the back hexagon with a slim open-end wrench and loosen the front hexagon counter-clockwise, until the inner bush moved a few millimeters out of the outer bush.

služby: online CAD katalog

Dodávané 3D modely, obrázky a technické výkresy jsou vyrobeny s velikou péčí. Přesto je vyloučena odpovědnost za přesnost a správnost těchto údajů.

součást skupin produktů:

číslo výrobku d
[mm]
D
[mm]
L
[mm]
L 1
[mm]
B
[mm]
T
[Nm]
Fax
[kN]
Pw
[N/mm2]
PN
[N/mm2]
SW
[mm]
TA
[Nm]
hmotnost
[g]
61558220 CAD 20 30 36 17 10 248 24,8 202 155 36 160 162